In the event that the file does not meet the requirements for any reason, an email will be sent back indicating this and awaiting correction, the position will not be kept in the queue until it is received again.

As the printing of an object involves an analysis of the best way of printing, we may contact you to work on the model. It is therefore advisable to send the parts in good time.

PLA filament, ABS, PETG, Flexible 95A, composites, etc.

For 3D printing, all consumables will be provided by students, teachers, etc.

All the material will be tested by the workshop, you cannot bring your own material and start the process except for specific exceptions which have previously been consulted.

To facilitate the choice of the appropriate material, the following brands are recommended:

– Fillamentum
– SmartMaterials
– Prusament
– Filament PM

The following, however, will not be accepted:

– Filamento León 3d
– Filamento «Luminoso»
– ABS»

We can’t be your remnant store, so we can’t guarantee that material left over from cutting or that you bring from home to be cut in the long term won’t have been turned into key rings.